Garden Radiance GS4150NGBK Instruction Manual

Owner’sManualGS4150NGBKGS4150NGSSIMPORTANTRead this manual carefully before assembling, using or servicing this heater. Keep this manual for future re

9.Your heater was designed and approved for outdooruse only. Do NOT use it inside a building, garage, orany other enclosed area..Make sure surrounding

10If you experience any ignition problem pleaseconsult “Troubleshooting” on page 11.Caution: Avoid inhaling fumes emitted from theheater’s first use

11TroubleshootingIf the problem is: And this condition exists: Then do thisPilot won’t lightBlockage in orifice or pilot tube Clean or replace orifice

12.Gas odor with extreme yellow tipping of flame..Heater does NOT reach the desired temperature..Heater glow is excessively uneven..Heater makes poppi

1ContentsGeneral Safety Information... 1Assembly Instructions...Componen

2DANGER• EXPLOSION - FIRE HAZARD• Keep solid combustibles, such as building materials,paper or cardboard, a safe distance away from the heateras recom

3WARNINGDANGER• EXPLOSION - FIRE HAZARD• This heater is red hot during use and can igniteflammables too close to the burner. Keep flammables atleast 3

4Picture Qty DescriptionUsed inStep(s)4Medium Bolt 29 Small Screw 69Large FlatWasher4 & 79Small FlatWasher64Large Flange4 Req’d LargeFlangeNutsNut

5Step 3 – Attach Post to PostAttach lower post and upper post to the each end ofmiddle post.Using 4 screws to fasten them.Fully tighten all of the scr

6Load Head Assembly by inserting hose into post.Insert Head Assembly into post.Control knob should be above decal on post.Attach Head Assembly to post

7Step 7 – Attach Reflector Assembly to Studs.Support Heater..Slide 3 Large Flat Washers over threaded end ofStuds..Locate Reflector Assembly on 3 stud

8Leak CheckWARNING• Perform all leak tests outdoors.• Extinguish all open flames.• NEVER leak test when smoking.• Do not use the heater until all conn